Britec Tech Support Forum

Double clutch

03-26-2016, 03:32 PM

Yes

Router Power Cycle

Switch your computers off.
Turn your router/modem off.
Unplug your router/modem and all cables from the wall.
Wait 60 seconds.
Plug your router/modem back in and turn on. (wait until lights go solid or router is fully booted)
Switch one computer on (doesn't matter which).

Router Reset

Reset Router to Factory Default Settings:

Typically a reset can be done by inserting something tiny like a paper clip end or pencil tip into a small hole labeled "reset" located on the back of the router.
Press and hold down the small button inside until the lights on the front of the router blink off and then on again (usually about 30 seconds)
In order to get to the router's server, type http:\\192.168.1.1 in the address bar and click Enter. You should see the log in window.
Fill in the password you have already found and you will get the configuration page.
Configure the router to allow you to connect to your ISP server. In some routers it is done by a setup wizard.
If you do not have a setup wizard you have to fill in the log in password your ISP has initially given to you. You can also call your ISP if you don't have your initial password.
Don't forget to change the routers default password and set a stronger, more complex password. Note down the password and keep it somewhere for future reference.

Problem solved. Thank you Big Grin

glad you get everything working

You might also want to see if there is a firmware update available Smile

you should leave the router firmware well only
if the router is working well

solved thread-closed